Removing The Computer Cover - Dell OptiPlex 330 dcsm Schnellreferenzhandbuch

8 VGA video
connector
9 serial connector

Removing the Computer Cover

CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
1 Follow the procedures in "Before You Begin" on page 10.
NOTE:
Ensure that sufficient space exists to support the removed cover.
NOTICE:
Ensure that you are working on a level, protected surface to avoid
scratching either the computer or the surface on which it is resting.
2 If you have installed a padlock through the padlock ring on the back panel,
remove the padlock.
3 Slide the cover release latch back as you lift the cover.
Connect the monitor's VGA cable to the VGA connector on
the computer.
On computers with a video card, use the connector on the
card.
Connect a serial device, such as a handheld device, to the
serial port. The default designation is COM1 for serial
connector 1.
For more information, see "System Setup Options" in the
online User's Guide.
Quick Reference Guide
33