Eibenstock PLD 182.1 NT Originalbetriebsanleitung Seite 22

 When securing the drill stand with anchors and fasteners to the
workpiece, ensure that the anchoring used is capable of holding
and restraining the machine during use. If the workpiece is weak or
porous, the anchor may pull out causing the drill stand to release from
the workpiece.
 When securing the drill stand with a vacuum pad to the workpiece,
install the pad on a smooth, clean, nonporous surface. Do not
secure to laminated surfaces such as tiles and composite coating.
If the workpiece is not smooth, flat or well affixed, the pad may pull away
from the workpiece.
 Ensure there is sufficient vacuum before and during drilling. If the
vacuum is insufficient, the pad may release from the workpiece.
 Never perform drilling with the machine secured by the vacuum pad
only, except when drilling downwards. If the vacuum is lost, the pad
will release from the workpiece.
When drilling through walls or ceilings, ensure to protect persons

and the work area on the other side. The bit may extend through the
hole or the core may fall out on the other side.
 Ensure that the drill is securely attached to the drill stand before
using it. Otherwise, the drill may slip in the drill stand, which can lead to
a loss of control.
 Secure the drill stand on a stable and even surface. If there is a
chance that the drill stand will slip or wobble, the safe and steady
operation of the drill cannot be guaranteed.
Store idle drill stands out of the reach of children. Do not allow

persons unfamiliar with the tool or these instructions to operate the
tool. Tools can be dangerous in the hands of untrained users.

Before carrying out any work on the drill stand or drill, during work
breaks and when not using the drill stand, secure the drill stand
against unintentional movement by tightening the parking brake.
 The safety and operating instructions for the drill stand and the
accessories being used are to be strictly observed!
 Always work in a carefully considered way and do not use the tool
if you are lacking consideration.
 Store the machine in a safe manner when not being used. The
storage location must be dry and lockable. This prevents the machine
from storage damage, and from being operated by untrained persons.
For further safety instructions, see the enclosure.
The PLD 182.1 NT is made in protection class I. For protection purposes the
machine can only be run with a GFCI. The machine is standard equipped
with a PRCD switch in the cord which allows to connect the unit direct to a
socket.
Electrical Connection
21