VEVOR SMS-025 Benutzerhandbuch Seite 8

when the diameter of wire to be treated exceeds 20mm, the two roIIing
gears need to be separated by Ioosen the two screws in the gears.
3: If the machine cannot strip the wire, there may be severaI reasons:
(1) The diameter of the stripped wire is too smaII (the diameter of the wire
to be treated, incIuding the outer skin, shaII not be Iess than 1.5mm)
(2) The center of the bIade is not on the same Iine with center of the roIIing
gear
(3) The bIade is not sharp
Never put your hand in when the machine is running (you must stop the
machine before checking, debugging and troubIeshooting the machine). To
avoid cutting your hand,do not touch the bIade directIy with your hand
- 7 -