Electrolux ERG1401AOW Benutzerinformation Seite 23

Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Intensive Cool-
ing, or after changing the
temperature.
Water flows into the refrig-
erator.
Temperature cannot be set. The FastFreeze or Intensive
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The Intensive Cooling func-
tion is switched on.
This is normal, no error has
occurred.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Cooling function is switched
on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
ENGLISH
Solution
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Intensive Cooling
function".
The compressor starts after
a period of time.
Make sure that food prod-
ucts do not touch the rear
plate.
Switch off FastFreeze or In-
tensive Cooling manually, or
wait until the function resets
automatically to set the
temperature. Refer to "Fast-
Freeze or Intensive Cooling
function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
23