HOMCOM B71-054 Bedienungsanleitung Seite 6

1. Remove the left rear Axle Nut (A) from the bike.
2. Fasten the Hitch Connector (9) onto the rear axle using the existing Axle Nut as
shown.
3. Ensure wheel is properly aligned and chain properly tightened as described in
bicycle owner's manual.
4. Install and tighten Axle Nut as described in bicycle owner's manual.
Attaching Safety Strap to Bike
Steps:
1. Route Safety Strap (20) around Bike's Frame (A) as shown.
2. Securely fasten Strap Clamp (B) to Bracket (C) as shown.
3. Ensure wheel functions properly with no interference.
WARNING:
NOTE: To remove the Trailer from the bike, reverse these installations steps.
Ensure wheel is properly aligned and chain properly tightened as described in
bicycle owner's manual. Install and tighten Axle Nut as described in bicycle owner's
manual.
Installing Flag
The Flag slides into the Slot in the side of the left Frame.
Steps:
1. Connect both sections of the Flag as shown.
2. Locate the Slot on the rear corner of the frame and slide flag shaft all the way in
so that it is secure.
5
EN