Virutex FC116U Gebrauchsanweisung Seite 30

D2
D1
Gt
E
Gp
L
E
M
H1
I1
17. DUST COLLECTOR ATTATCHMENT
over the opening of the box to be made, allows the connection
of the Virutex AS182K, AS282K, AS382L and ASC682 dust co-
llector or another Industrial Dust Collector for the collection of
trimming chips
18. REMOVING THE SPLINE SHAFT
chassis until the motor axis is locked and remove the spline shaft
F
G
19. CHANGING THE BRUSHES
place with new original VIRUTEX ones, checking that they slide
smoothly on the inside of the guides. Ensure when mounting the
inside. It is advisable to leave the machine running for a few mi-
nutes after a change of brushes. Take advantage of the change
of brushes to check the state of the collector. If this shows signs
of burns or wear and tear, it is advisable to take it to VIRUTEX
technical service for repair.
I1
H1
20. LUBRICATION AND CLEANING
F1
lightly oiled cloth, in order to smooth the two movements. It is
G1
important always to clean the machine carefully after use, with
a dry air jet.
Always keep the power supply cable in perfect condition.
Make sure that the machine is disconnected
from the mains before any handling is done.
-