Virutex FC116U Gebrauchsanweisung Seite 24

"N3"
"Nt"
"N2"
N2-N3= X mm
V
S1
"rs"
N2-N3= X mm
"rs1"
S2
S1
S
12.1. TRIMMING THE FITTING FOR THE FRONT PLATE OF
N1
THE LOCK FOR A MAXIMUM "Nt" OF 170 mm
Check that the trimmer is disconnected from the
mains.
CHANGING THE TRIMMING
"rs"
attach a mortising bit of the correct size to the machine, fo-
llowing the instructions in section 6 of the manual.
"rs1"
MEASURING, MARKING REFERENCE POINTS AND PLACING
THE FC116U ON THE DOOR
the two edges of the front of the lock, giving you measurements
Hold the machine against the door, aligning the upper edge of
the lock box and the front plate for the lock.
in the alignment of the machine's trimming path with the centre
of the front plate for the lock.
ADJUST THE TRIMMING PATH
corresponding division of the measurement NT, using the scale
-
-