Bosch GLM 50 C Professional Originalbetriebsanleitung Seite 38

OBJ_BUCH-2450-005.book Page 38 Thursday, August 25, 2016 8:38 AM
38 | English
Wall Surface Measurement (see figure E)
The wall surface measurement is used to determine the sum of several individual sur-
faces with a common height.
In the illustrated example, the total area of several walls should be determined, which
have the same ceiling height H, but different lengths L.
Select the wall surface measurement
Measure the ceiling height H as with a length measurement. The measured value is
displayed in the top measured-value line. The laser remains switched on.
Then measure the length L
calculated and displayed in the result line e. The last length measured
1.291 m
H
value is in the bottom measured-value line d. The laser remains
0.0° 2.583 m
L
switched on.
2.583 m
L
3.336 m
2
Now measure the length L
value displayed in the measured-value line d is added to the length L
The sum of the two lengths (displayed in the middle measured-value line d) is multi-
plied by the saved height H. The total surface value is displayed in the result line e.
You can measure any number of lengths L
multiplied by the height H.
The requirement for a correct area calculation is that the first measured length (for ex-
ample the ceiling height H) is identical for all sub-areas.
Stake out function (see figure F)
The stake out function repeatedly measures a defined length (distance). These
lengths can be transferred to a surface, for example to enable material to be cut into
pieces of equal lengths or to install stud walls in a drywall construction. The minimum
adjustable length is 0.1 m, the maximum adjustable length is 50 m.
Select the stake out function
Set the desired length. Using button 7 [Func] select the corresponding digit/position
and change the value with button 3 [+] or button 8 [–].
Begin the stake out function by pressing the measuring button 2 [
move away from the starting point.
The measuring tool continuously measures the distance to the starting
point. The defined length and the current measured value are thereby
0.81x 0.500m displayed. The lower or upper arrow displays the shortest distance to
0.483 m
the next or last marking.
Note: The continuous measuring enables you to set a measured value
1
as a defined length by pressing the button 4.
1 609 92A 23J | (25.8.16)
.
of the first wall. The surface is automatically
1
of the second wall.The individual measured
2
, which will be automatically added and
X
.
.
1
] and slowly
Bosch Power Tools