Display Illumination; Measuring Functions - Bosch GLM 50 C Professional Originalbetriebsanleitung

OBJ_BUCH-2450-005.book Page 35 Thursday, August 25, 2016 8:38 AM
To select the reference level, press button 4. Use button 3 [+] or button 8 [–] or but-
ton 4 to select the desired reference level. The rear edge of the measuring tool is pre-
set as the reference level every time the measuring tool is switched on.
"Basic Settings"
To enter the "basic configurations" menu (i) press and hold the button 7 [Func].
Select the respective basic configuration and your setting.
To exit the "basic configurations" menu, press the On/Off button 5 [

Display Illumination

The display illumination is continuously switched on. When no button is pressed, the
display illumination is dimmed after approx. 20 seconds to preserve the batteries/re-
chargeable batteries.

Measuring Functions

Length Measurement
Select the length measurement
To switch on the laser beam, briefly press the measuring button 2 [
To measure, briefly press the measuring button 2 [
shown at the bottom of the display.
Repeat the above-mentioned steps for each subsequent measurement.
The last measured value is at the bottom of the display, the penultimate
7.620 m
measured value is above it, and so on.
0.0° 8.890 m
10.160 m
11.430 m
Continuous Measurement (Tracking)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
Select the continuous measurement
To switch on the laser beam, briefly press the measuring button 2 [
Move the measuring tool until the required distance value is indicated in the bottom
of the display.
Bosch Power Tools
.
]. The measured value will be
.
1 609 92A 23J | (25.8.16)
English | 35
] again.
].
].