Iwata SPRING JET IS800 Bedienungsanleitung Seite 9

1. Release built up moisture in moisture trap.
2. Turn off compressor.
3. Release leftover air by engaging main lever/trigger of your airbrush (being careful of any excess paint).
To avoid injury, or damage to your product before performing maintenance and/or inspection:
• Release remaining air in unit away from you and others.
• Turn compressor off.
• Remove power cord from electric outlet.
CHANGING THE AIR INTAKE FILTER
The filter only needs to be changed if it's significantly dirty or dirty enough to cut air flow into the compressor. Inspect your air intake filter
once per week with heavy compressor use.
• Use your finger to pull out the filter cover and air intake filter.
• Remove the sponge-like air filter and replace with new air intake filter (ISAF1 – 10 pack).
• Push filter cover with new air intake filter back into place.
IS800 SPRINT JET - RELEASING BUILT-UP MOISTURE IN THE MOISTURE FILTER
• Press a paper towel against the air adjustment valve located at the bottom of the moisture trap.
• Release any collected moisture by turning the air adjustment knob toward the "–" sign allowing moisture trap to drain.
Note: For optimal performance and to avoid early wear, empty at end of each session.
IS850 SMART JET - RELEASING BUILT-UP MOISTURE IN THE MOISTURE FILTER
• Press a paper towel against the drain valve located at the bottom of the moisture trap.
Note: For optimal performance and to avoid early wear, empty at end of each session
ENDING A SESSION
MAINTENANCE
WARNING
9