Iwata SPRING JET IS800 Bedienungsanleitung Seite 4

• Always work in well-ventilated areas away from volatile, or flammable fluids and vapors.
• Stop operation immediately should you hear abnormal sounds or vibrations such as clanking.
• Compressor can become hot during prolonged use. Avoid running continuously without a break for more than 40 minutes at a time.
Use caution when handling compressor at this time.
• Motor is thermally protected and automatically shuts off when overheated. If this occurs, turn compressor off and wait to restart until
unit has cooled down.
• DO NOT place air compressor between you and your work area or directly under an area being sprayed. This could allow for over spray
to flow into air intake of compressor causing internal damage to unit.
NOTE: Suggested use of an air filter is highly recommended to minimize intake of overspray, moisture, dust...etc.
Minimizing potential interference of proper compressor operation.
Moisture will condense in the clear glass of the moisture trap assembly. To release, open the pressure adjustment valve knob with a paper
towel pressed underneath or by pressing up on the moisture drain valve at the bottom of the moisture trap glass depending on your
compressor model.
During extra humid conditions, condensation may build up and rest in hose(s). Remove air hose(s) at end of session and drape overnight to al-
low to drain/dry excess moisture.
Note: How often you need this will vary depending on humidity and amount of use.
CAUTION
NOTE ON MOISTURE
4