Iwata SPRING JET IS800 Bedienungsanleitung Seite 7

1. Screw large end of Straight Air Hose snuggly onto air outlet of Moisture Filter Assembly. (Avoid over tightening both ends of hose to avoid
early wear)
2. Screw small end of Straight Air Hose snuggly to airbrush.
a. Note: If using a brand of airbrush other than Iwata, use appropriate option from included adapter kit. *While not guaranteed to fit all
brands beyond Iwata Airbrushes, they're found to fit most.*
3. Plug compressor into a grounded wall outlet that meets all local government specifications.
a. Note: Not for use with extension cords/power strips. *Please refer to name plate on bottom of compressor for power and voltage requirements.*
4. Turn compressor ON by pressing down on On/Off Switch on top of unit.
5. As the unit is being used, water may collect in the moisture filter's clear, plastic bowl. Release the water by following the maintenance
instructions.
a. Note: Upon first use, allow to run for 5 minutes. to ensure compressed air is being released and no abnormal sounds or vibrations are present.
1. With your airbrush connected and the compressor powered on, depress main lever/trigger of your airbrush. Pressure registered on your gauge
represents "Working Pressure. " Results vary depending on your airbrush's performance requirements. *Learn More at Iwata-Airbrush.com*
2. Adjust working pressure by turning pressure adjustment knob toward + or – while engaging main lever/trigger of airbrush.
3. For max working pressure, close pressure adjustment valve by turning knob towards +.
IS800 SPRINT JET — GETTING STARTED
IS800 SPRINT JET — REGULATING THE WORKING PRESSURE
7