Iwata SPRING JET IS800 Bedienungsanleitung Seite 8

1. Attach regulator assembly to compressor output using winged adapter, tightening clockwise.
a. Note: Avoid over tightening of fittings and hoses to avoid early wear
2. Screw Coiled Air Hose onto compressor output located above Auto Stop Pressure Switch.
3. Screw other end of Coiled Air Hose onto small side facing output on Regulator Assembly.
4. Screw large end of Straight Air Hose onto front facing output on Regulator Assembly.
5. Screw small end of Straight Air Hose to airbrush.
a. Note: If using a brand of airbrush other than Iwata, use appropriate option from included adapter kit. While not guaranteed to fit all brands
beyond Iwata Airbrushes, they're found to fit most.
6. If using IS850SA choose the appropriate international plug.
7. Plug compressor into a grounded wall outlet that meets all local government specifications.
a. Note: Not for use with extension cords/power strips.
8. Turn compressor on by pressing On/Off Switch.
a. Note: Motor will power on and off as stored air depletes, running to replenish the stored air.
9. Adjust air pressure by pulling up on regulator knob, turning to desired pressure then pushing down to lock in place
a. Note: Turn knob toward "+" to increase, "-" to decrease.
10. As the unit is being used, water may collect in the moisture filter's clear, plastic bowl. Release the water by following the maintenance
instructions.
a. Note: Upon first use, allow to run for 5 minutes. to ensure compressed air is being released and no abnormal sounds or vibrations are present.
IS850 SMART JET — GETTING STARTED
8