Overview Of Dmx Channels - Involight Led Rx350 Bedienungsanleitung

Play built-in programs:
Press the "Mode" button until the display shows "Pr.01". The device now plays automatic program 1. You can set a
total of 42 automatic program sequences. To do this, simply select the program with the "Up" and "Down" buttons.
The automatic programs can be set in a variety of ways: Press "Setup" and the display shows "SP.00". With "Up"
or "Down" you can then influence the speed of the LED pattern change. Another press on "Setup" takes you to the
"FS.00" menu. With the "Up" / "Down" buttons you can now set the flash frequency of the LEDs flashing from slow
to fast.
Automatic mode:
Press the "Mode" button until the display shows "Auto". Automatic mode is activated. Similar to the built-in
programs, this can also be adjusted in many ways: Press the "Setup" button to display "n.001" on the display. With
the "Up" or "Down" button you can change this value from 001 to 100. This sets the speed and type of LED lighting
sequence. Press "Setup" again and the display shows "SP.00". With "Up" or "Down" you can then influence the
speed of the LED pattern change. Another press on "Setup" takes you to the "FS.00" menu. With the "Up" /
"Down" buttons you can now set the flash frequency of the LEDs flashing from slow to fast.
Set music-controlled mode:
Press the "Mode" button until the display shows "Soun". Sound mode is activated. Press "Setup" and "S1.31"
appears. If you now briefly press "Up" or "Down", you will come to the second sound mode "S2.31". The modes
generally differ in the program sequence. You can decide which program is more suitable according to your
personal taste and purpose. In both modes you can set the sensitivity by briefly tapping the "Up" and "Down"
buttons. "S1.00" = least sensitive and "S1.31" = most sensitive. The same applies to the "S2.XX" mode.
Set master / slave mode:
The "RX-350 V.2" can be linked to other devices. To set a device as a "slave", press the "Mode" button until "Slav"
appears on the display.
DMX mode:
To set the DMX mode, press "Mode" until the display shows "d.001". The DMX mode is set and the start address
is 001, as can be seen in the display. You can choose between a 3-channel and a 2-channel mode. To do this,
press the "Setup" button. The device shows "D-P1" for the 3-channel mode and "d-P2" for the 2-channel DMX
mode. You can set the start address with the "Up" and "Down" buttons (001 - 512)
Set static color effect:
Press the "Mode" button until is displayed. You can now use the "Up" and "Down" buttons to choose between 12
different static color effects.

3.2 Overview of DMX channels:

NOTE: Basic knowledge of the DMX512 control standard is required so that the device can be operated and
programmed correctly with a DMX controller.
Channel
1
All manuals and user guides at all-guides.com
DMX mode with 3 channels, channel assignment:
Value
001 – 005
006 – 011
012 – 017
018 – 023
024 – 029
030 – 035
036 – 041
042 – 047
048 – 053
054 – 059
060 – 065
066 – 071
072 – 077
078 – 083
084 – 089
090 – 095
Program 01
Program 02
Program 03
Program 04
Program 05
Program 06
Program 07
Program 08
Program 09
Program 10
Program 11
Program 12
Program 13
Program 14
Program 15
Program 16
17
Function