VEVOR ROPE-H-9 Benutzerhandbuch Seite 6

STEP 1: Put on your safety harness making all necessary adjustments and safety
checks as per the manufacturers instructions.
STEP 2: Once you have reached your desired climbing height, attach the Safe-Line
to the tree just above the treestand by wrapping the knotted looped end around the
trunk and then pulling the rest of the line through the knotted loop until snug. NOTE:
The looped end must be securely knotted.
STEP 3: Attach the harness carabiner to the loop on the Prusik Knot while making
sure that the knot is able to move down the length of the rope without interference.
STEP 4: Next, descend the tree while regularly adjusting the Prusik Knot so that it is
always just above you. DO NOT pull/hold the Prusik Knot constantly while
descending as this may cause the Safe-Line to fail, resulting in injury or even death.
STEP 5: Once on the ground, disconnect the harness from the Prusik Knot and
loosely tie the bottom of the Safe-Line to the base of the tree. Make sure that the
Prusik Knot is still able to move from the top to the bottom of the tree without
interference.
Hunting Safety Line
Use-pattern
1）Feed the loop of the end of the safety link through one of the waist loops.
2）Then feed another end knot through the loop end and pull tight.
3）Wrap the free end of the around the tree to fasten to another waist loop by a
carabiner.
4） Adjust the prusik knot to a comfortable distance from the tree.
4