VEVOR ROPE-H-9 Benutzerhandbuch Seite 15

3.1 Do a tactile inspection of the core over the full length of the rope, as
indicated in the drawing. This allows you to detect areas where the core
is damaged (hard spots, swelling, soft or crushed areas...).
4) Checking the condition of the core
4.1 To check the length of your rope, follow the steps below:1. Completely
uncoil the rope.2. Check the middle mark of the rope. There is a simple
way to find the middle of the rope: hold the two rope ends together, then
slide the two strands simultaneously through your hands until the middle
of the rope is reached. If your rope has a middle mark, check it for
accuracy. If the mark is OK, go to the next step. If the mark is not in the
right place or if there is no middle mark, place a piece of adhesive tape
at the rope's midpoint to help measure its length.
Reasonfor
No. Date
check
□Periodic
1
□Additional
□Periodic
2
□Additional
□Periodic
3
□Additional
□Periodic
4
□Additional
□Periodic
5
□Additional
□Periodic
6
□Additional
DEVICE PERIODIC CHECK SHEET
Name and
signature of
the person
responsible
for checking.
Notes (defects
found, repairs
performed or
otherrelevant
information)
13
Date of
Check
next
results
check
□Device fit
for use.
□Device
unfit for use
□Device fit
for use.
□Device
unfit for use
□Device fit
for use.
□Device
unfit for use
□Device fit
for use.
□Device
unfit for use
□Device fit
for use.
□Device
unfit for use
□Device fit
for use.
□Device
unfit for use