Floorboard Removal/Maintenance; Brake Adjustment - Burley Bark Ranger Benutzerhandbuch Und Sicherheitshinweise

Floorboard Removal/
Maintenance
1
From the back of the trailer, push the
bottom of the floorboard upwards
towards the inside of the trailer, on
both corners, until it snaps past the
plastic retainers.
2
rotate floorboard upwards and slide
towards the back of the trailer to remove.
3
reinstall by sliding front of the
floorboard under front frame tubes
and rotating downwards.
4
Push floorboard firmly down and ensure
all snaps are engaged on flooboard.
BArK rAnGEr & BArK rAnGEr XL

Brake Adjustment

> 1 0 m
note
Brake cables may stretch over time with
product usage. Follow the steps below for
any needed adjustment to ensure proper
brake activation.
1
remove the wheels and activate
the brake lever. the brake pins
should protrude a minimum of
10mm. If less than 10mm, they will
need to be adjusted to ensure
proper brake function.
ENG DEU
m
2
To adjust the brake pin protrusion:
release the brake and remove
the floorboard.
raise the brake cable flap on the
brake lever side of the trailer
Adjust the cable by rotating the
barrel adjuster counterclockwise to
tighten the cable
rotate the left barrel adjuster for the
left-side brake and the right barrel
adjuster for the right-side brake.
Secure the adjuster by tightening the
nut against the plastic housing using
an 8mm wrench
Activate the brake lever and check
for 10mm of brake pin protrusion.
FRA ESP
B
A
c
3
release the brake and activate it
to ensure proper function.
4
.
A
Lower the brake cable flap and
replace the floorboard.
B .
C .
ASSEMBLY & uSE
17