Handlebar Installation/Adjustment - Burley Bark Ranger Benutzerhandbuch Und Sicherheitshinweise

Handlebar Installation/Adjustment

1
Insert handlebar into receiver, depress
both yellow handlebar receiver buttons
and insert the handlebar past the buttons.
2
release the buttons and slide the
handlebar until it clicks into place.
3
the handlebar has two height settings.
depress each handlebar receiver button
to slide the handlbar to desired setting.
Ensure that both sides of handlebar
are in the same height setting.
4
Before use, push down and then pull up
slightly on the handlebar grip to ensure
that the handlebar is locked into place.
5
to remove handlebar, depress
both buttons and slide
handlebar out completely.
14
ASSEMBLY & uSE ENG DEU FRA ESP BURLEY.COM