Installing The Wheel Guards; Installing The Tow Bar; Removing The Tow Bar - Burley Bark Ranger Benutzerhandbuch Und Sicherheitshinweise

Installing the Wheel Guards

1
Align the wheel guards with
the tow bar reciever.

Installing the Tow Bar

A B
1
Slide the tow bar into the tow bar
receivers until the first hole is aligned
with the hole in the rear receiver.
the red safety collar should be
flush with the front of the tow bar
receiver, which indicates that the
tow bar has been fully inserted.
12
ASSEMBLY & uSE
2
Slide the wheel guard into the tow bar
receiver until it snaps into place. Lightly
bend front tabs inward when inserting.
2
Insert the retaining pin from the
top through the aligned holes
ENG DEU
3
repeat on the opposite side.
3
Make sure the retaining pin has
locked properly as shown.
FRA ESP
Removing the
Tow Bar
1
remove the retaining pin.
A B
2
Press the tab on the wheel
guard to depress the detent.
remove the tow bar.
BURLEY.COM