Chain Oil; Start/Stop - Texas A/S Smart Chainsaw 100 Benutzerhandbuch

5. Chain oil

1
3
Always use chain oil to lubricate the guide bar and chain. Standard engine oil is not
suitable for this purpose.
We recommend Texas Chain Oil (product number: 90406590), which has the correct
viscosity. Remove the oil tank cover (1) and fill with oil. Always clean around the oil lid!
Check the oil level in the oil glass (4) on the right side of the chainsaw every three months.
The amount of oil must never be less than the minimum mark, otherwise there is a risk that
the chain is not lubricated, which may lead to it becoming damaged.
For extra lubrication, use the oil hole (5) on the guide bar's tip. Use a disposable syringe
and put the oil in the oil hole at the same time that you pull the chain.
Always ensure that power is disconnected and that the chain brake (2) is deactivated.
The cord holder (3) must be used to minimise the tension in the power cable on the
chainsaw.

6. Start/stop

1. To start the chainsaw, activate the "start" switch.
2. You must hold in the switch on handle's left side before
the chainsaw can start.
3. The chainsaw will stop if you release the switch.
4. The chain brake handle must always be pulled back
during use.
5. Check that the chain is getting lubricated. First time
start without the oil lid fitted, can help the feed the oil to
the chain. Remember to fix the lid again!
4
2
5
Start
14