Fitting Guide Bar And Chain - Texas A/S Smart Chainsaw 100 Benutzerhandbuch

4. Fitting guide bar and chain

1. Remove the side cover.
2. Put the chain around the nose wheel on the guide bar.
Once the chain has good contact with the nose wheel,
put the guide bar into the engine unit, and position the
chain on the guide bar.
3. NB: Ensure that the chain is facing the correct way
(forward).
See drawing.
4. Fit the side cover.
5. Tighten the cover nut using fingers.
6. Lift the guide bar tip and tighten the chain using the tension screw on the side cover.
The chain must be tightened enough so that you can just lift a link free of the track on
the guide bar.
7. Safely secure the guide bar and side cover.
Nose wheel
13