Tools Needed For The Assembly; Your Radio System - Carson X-10NB Chassis Betriebsanleitung

Tools Needed for the Assembly

Modelling knife 300074053
Philips screwdriver (small and big)
and hex-wrench
1,5 / 2 / 2,5 mm 300074023
a. Your Radio System
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Engine throttle
servo
Instant adhesive 300053339
Hexagonal wrench 300013118
(only for RTR version)
Batteries for receiver
Switch
Steering servo
Needle nose pliers 300074034
Tweezers 300074003
on)
CARSON X10NB Chassis
Scissors 300013305
Side cutter 300074035
Transmitter
17
GB