Truma iNet X Connect Kurzanleitung Seite 4

Pflichten des Benutzers und Betreibers
• Sicherstellen, dass das Connect in allen Betriebs-
phasen ordnungsgemäß betrieben und bedient
werden kann.
EN Safety instructions
Installation
The Connect is supplied with voltage via the panel.
The Connect does not require its own power supply.
The power supply for the Connect is provided via the
cable supplied.
DANGER
Electric shock from live parts
Live parts may have to be touched during installation.
Before installing the Connect:
• Remove the 230 V connector cable from the exter-
nal socket.
• Switch off the independent 230 V power supply
(e.g. solar panels, inverter, generator).
• Switch off fuses and / or residual current cir-
cuit-breakers (RCCB) in the vehicle.
General safety
• Read and closely follow the safety instructions to
prevent risks and damage to people and property.
• Read and observe the operating and installa-
tion instructions for the Connect and supporting
documents for other devices, such as gas supply,
heating system, air conditioning system, and the
vehicle carefully and keep them in a safe place for
subsequent use.
• Observe local laws, guidelines and standards asso-
ciated with the use and operation of the Connect.
Safety instructions for the Connect
• The Connect must not be operated unless it is in
technically perfect condition.
04
• Only carry out repairs yourself if the solution is
described on the panel display or in the app.
• No repairs or modifications to the Connect are
allowed.
• A defective Connect may only be repaired by Truma
Service.
• Observe the safety instructions in the operating
instructions for the panel.
• If the housing of the Connect is damaged or liquid
has run into the housing, do not insert the plug of
the cable into the Connect or disconnect the plug of
the cable from the Connect.
Handling electricity
Only qualified electricians may work on electrical
systems of the vehicle.
• Observe country-specific and voltage-related rules
and regulations.
• Take account of the vehicle's specific features.
• Ensure the necessary workplace safety.
Battery voltage 12 V DC
The Connect is supplied via the on-board power
supply by a 12 V battery. In case of high electrical
loads or a short circuit very high currents may flow in
the cables which make the cables hot and may lead
to cable fire.
• Use only original cables, panel cables and fuses.
Original spare parts
Using parts (additional components, spare and wear-
ing parts) outside the manufacturer's specification
may have an adverse effect on the function or safety
of the Connect and may damage the vehicle and limit
the warranty and manufacturer's liability.
• Use only original additional components, spare
and wearing parts from Truma Gerätetech-
nik GmbH & Co. KG.
Truma iNet X Connect – Kurzanleitung