Filling Mode - Autool Sc301 Benutzerhandbuch

Filling mode

●
Press the [Start/Stop] button to initiate machine operation. The
machine will begin the vacuuming process. Wait for the
vacuuming to complete, and the machine will automatically
enter pressure holding mode for 60 seconds. Afterward, it will
provide an automatic leak detection indication.
●
The leak testing function utilizes LED lights to inform the user
about the coolant tank's condition. When there is a leak, the
red LED light remains continuously lit, while in the absence of
a leak, the green LED light remains continuously lit.
NOTE
Begin by opening the drain valve before starting the operation.
(The vent valve is considered open when it aligns parallel to
the air hose.)
Before adding new coolant, the old coolant in the water tank
must be drained first. Otherwise, it will mix with a large amount
of old coolant, affecting the performance of the cooling system
and preventing the coolant from providing adequate cooling
and anti-freeze protection for the engine and other compo-
nents.
After completing the Testing Mode, select the Filling Mode to add
coolant into the vehicle's cooling system.
● Connect the filling hose to the vehicle and place the coolant
inlet hose into the coolant container.
●
Choose the appropriate gear level (for older vehicles, it's
advisable not to use the higher gear levels).
●
Press the [Start/Pause] button to initiate the vacuuming
process. Once vacuuming is complete, the machine will
automatically start adding coolant to the system.
●
After the filling is completed, press the [Stop] button.
●
After refilling, disconnect the connector from the vehicle.
10