EcoDim ECO-DIM.11 MULTICONTROL Handbuch Seite 3

Wiring diagram
L wire
(Phase wire, often brown)
N wire
(Neutral wire, often blue)
LED
LOAD
(Switching wire, often black)
Setting min. light level
The minimum light level is easily adjustable
via the potentiometer on the dimmer.
1. Factory default minimum light level setting
is position 1.
2. The minimum light level setting should
be set the same on all dimmers connected
in pairs.
0 : 0%
1 : 5%
2 : 10%
3 : 15%
EN
Manual
ECO-DIM.11
MULTICONTROL
Led dimmer trailing edge (R,C)
Note:
• This is a two-wire dimmer and it should be connected as shown under the heading
'Wiring diagram' .
• Installation of the dimmer on a 230V mains should be carried out by a qualified
professional, taking into account national regulations. Ensure that the electricity is
switched off during all work.
• Dimmer is not suitable for wound/magnetic or core transformers.
Dr. Huber Noodtstraat 89
7001 DV, Doetinchem, Netherlands
(Imported by NJ Trading B. V .)
EcoDim B.V.
Made in China