TERMOFOL TF-SWT400 Benutzerhandbuch Seite 19

Step 3:
Wait till the connecting status shows 100% to finish the settings and the WIFI signal on the control box will
stop flashing.
If you still fail to establish a connection, please power off the heater and power it back on again after a few se-
conds. Long press the "Timer" button on the touch screen for 5 seconds until the Wifi indicator is flashing slowly
and repeat the connection process under the AP mode.
If above procedure is not working, please try to reset to the factory mode and try the connection again.
If all the above is not working and the Wifi single light is flashing as expected, please try to disconnect an
already connected smart device from your current Wifi router and try to connect this heater to the Wifi router.
2 3
4
5 6