Jimmy bewinch R9 Bedienungsanleitung Seite 9

Note:
1.To ensure better use, leave the machine powered on even if it is long idled.
2.If the device hasn't been used for more than 24 hours, it is recommended to drain 98℃ hot water for 5
seconds before using again.
3.When the device is turned on for the first time, At first purification process there will be large amount of
bubbles discharged to raw water tank and raw water will become turbid. It is normal physical phenomenon
and bubbles will disappear after standing for a few minutes. Device can be used normally.
Display indicator description and usage
1
2
3
4
5
1.Raw water TDS indicator
2.Child lock indicator
3.Outlet water temperature
indicator
4.Error indicator
Water temperature
icon button
5.Water temperature icon button
6.Pure water TDS indicator
7.Raw water replacement
indicator
8.Water purification indicator
Temperature icon button
Touch the temperature icon to select water temperature. The water
temperature available is ambient temperature, 45 ℃、 55 ℃、 65 ℃、
75 ℃、 85 ℃、 98 ℃ . In the process of dispensing water, when
dispensing water at ambient temperature, the water dispensing light
is blue. When dispensing hot water,the water dispensing light shows
red. Stop dispensing water, the water dispensing light goes out. When
flushing, the water dispensing light is green.
Note:
The machine is equipped with plateau mode, when taking 98 ℃ hot water, if
the temperature cannot reach 98 ℃ after 20 seconds, the plateau mode will be
automatically turned on to adjust the water temperature. If the altitude of the use
environment is more than 1500 meters, it is not recommended to use 98 ℃ hot
water at this time, there may be steam spraying, please be careful of scalding.
6
7
8
9
10
9.Filter life indicator
10.Water volume icon
button
7