Jimmy bewinch R9 Bedienungsanleitung Seite 8

Flushing before first use
Step 1 Fill raw water tank
Remove raw water tank cover, hold the handle of the raw water tank and lift it upward. Fill the
raw water tank with municipal tap water up to below handle and put it back to machine.
Step 2 Water purification start
Connect device to power supply to start purifying water, the water purification indicator "
up, when the water purification light goes out , it means that the water purification is completed.
Step 3 Drain pure water cup
1.Empty pure water cup and put it back to machine to continue purifying. After pure water cup is full,
empty it again. After emptying pure water cup for 3 to 5 times, you can start using the water purifier.
pure water
cup
2.You can also remove pure water cup and drip tray, put a container larger than 3.5L under the water
outlet, long press dispense tap for 5 seconds until the dispense tap light becomes green, to flush
the filter and water path.
Drip tray
6
raw water tank
cover
Dispense
tap
raw water
tank
" lights