Jimmy bewinch R9 Bedienungsanleitung Seite 12

Take hot water
First touch the temperature icon on display screen to select water temperature. The temperature
can be selected from 45 ℃、 55 ℃、 65 ℃、 75 ℃、 85 ℃、 98 ℃ . Press dispense tap to take
water of the chosen temperature, the dispense tap light becomes red. Press the tap again to
stop taking water.
Customize water volume
Touch the water volume icon to select the water output volume, which can be selected as 60mL,
90mL, 120mL, 200mL, 300mL, 500mL, press dispense the dispense button to dispense water of
specified volume.
Replace raw water
When the display screen shows " " , empty the remaining water in the raw water tank, fill the
raw water tank with water up to below the handle.
Flushing
If the product is idled for more than 72 hours, need empty three cups of pure water or use
flushing function. Press and hold the dispense tap for 5 seconds and loose after hearing the
" beep " sound, and the dispense tap light turns green, The device enters flushing mode. In
this mode, only the water purification light flashes. Water comes out of dispense mouth and
stops when pure water cup is empty. You can terminate flushing by pressing dispense tap. After
flushing stops, display screen automatically resumes user interface.
10