Jimmy bewinch R9 Bedienungsanleitung Seite 10

Water volume icon
button
Raw water / Pure
water TDS value
indicator
Filter life indicator
Water purification
indicator
Error indicator
Raw water
replacement
indicator
8
Water volume icon button
Touch water volume icon button to select fixed water volume to get.
The fixed water volume can be selected from 60mL, 90mL, 120mL,
200mL, 300mL and 500mL.
Raw water / Pure water TDS value indicator
TDS (Total Dissolved Solids) is a general value for inorganic salts and
heavy metals dissolved in water. It represents the amount of impurities
dissolved in water. Normally the lower the TDS value, the purer the
water is.
Raw water TDS value: Indicates the TDS value of the water in the raw
water tank when it is not filtered by RO membrane of the device.
Pure water TDS value: indicates the pure water TDS value after the
raw water is filtered by RO membrane of the device.
Filter life indicator
Filter life indicators 1, 2, 3 represent the service life of the 1st, 2nd
and 3rd stage filters respectively. Each indicator has 3 cells. The
more cells the indicator lights on, the longer the remaining life of the
filter. If the indicator light goes out, it means that the service life of the
corresponding filter has expired and the filter needs to be replaced.
Water purification indicator
After the power is powered on, the water purification indicator on the
display screen shows "
water purification indicator shows "
water cup rises, the water purification indicator will display one cell
water level " ". When the pure water cup is full, the display light goes
out and water purification stops. When the pure water cup is not in
place, the indicator "
Error indicator
When the system detects error, the error indicator "
flashes and beeps for 10 seconds and corresponding error warning
interface appears. Before the error is resolved, the device can not be
used. As long as the button is touched, the error indicator "
again with beep for 10 seconds.
Raw water replacement indicator
When the raw water tank is not installed or the water level is below the
minimum water level mark, the display shows "
for three time.
Note:
In the following situations, the raw water replacement indicator
and the remaining water in the raw water tank must be emptied and the raw water
must be refilled:
1.Raw water TDS value higher than
2.Water level is below the minimum water level mark.
". When the water purification starts, the
". As the water level in the pure
" flashes, the device stops purifying.
"
999 ", and the buzzer beeps.
" lights up,
" flashes
". The device beeps
" "
will light up,