Cosatto SUPA Bedienungsanleitung Seite 5

Footmuff 13- Fitting
Backrest 14- Lowering
15- Raising
Calf support 16- Lowering
17- Raising
Basket 18- Removing
Hood 19- Fitting
20- Opening
21- Extending
22- Using the viewing window flap
23- Using the hood pocket
24- Using the speaker
25- Using the multimedia device pocket
26- Removing
Drinks holder 27- Fitting
Raincover 28- Fitting
Seat cover Removal
29-
30-
31-
32-
33-
34-
35-
36-
Pushchair 37- Closing
Stand 38-
All manuals and user guides at all-guides.com
Push crotch strap retainer through seat (2).
Rotate "C" clip to expose its opening (3) and slide waist strap out of clip (4).
Refitting is a reversal of this procedure.
Open the harness 8 and remove chest pad & headhugger (1).
Push the harness straps through the footmuff & headhugger (2).
Attach the footmuff fabric fasteners to the rear of the backrest (3).
Refit headhugger & chest pads then close the harness.
Push the brackets onto the mounts on the chassis (1).
Attach the fabric fasteners to the outside of the seat unit (2).
Fit the rear of the hood behind the backrest and attach the fabric fastener (3).
Attach the straps to the front chassis tubing (4).
Removal is a reversal of step 19 .
Release primary lock (1) & secondary folding lock (2).
Release fabric fasteners at rear of backrest (1).
Rotate "C" clip to expose gap (1) and slide waist strap out (2).
Fold retainer flat (1) and push through slot in mounting block (2).
There are three retainers on each side of the pushchair. One on the front chassis
tubing (3) and two on the underside of the seat (4).
Disconnect "C" clip from under seat (1).
Disconnect double "D" ring strap under the calf support (1).
Slide seat cover off calf support end (1) and off the backrest tubing (2).
Prior to washing, unzip the top of the backrest section (1) and remove the three
backrest boards (2).
Refitting is a reversal of this procedure.
Ensure backrest is in the upright position 15 .
Always remove the raincover, placing it in the basket and fold the hood completely back.
Pull the ring upwards (1) then press down the secondary lock bar (2).
Push the handles forwards (3) until the auto lock engages (4).
Note: Take care not to damage the stand mechanism when folding. Pressing down
too hard on the pushchair can bend the stand arms (5).
The stand automatically unfolds when the pushchair is closed.
Note: To avoid injury ensure that your child is kept away when the pushchair is used
in free-standing mode.