eta Fenite Bedienungsanleitung Seite 14

EN
– For additional protection we recommend installation of current protection (RCD) with the nominal
release current not exceeding 30 mA. Ask a control technician or an electrician for advice.
– Always unplug the appliance from power supply if you leave it unattended and before
assembly, disassembly or cleaning.
– CAUTION – Do not use the appliance with a program, time switch or any other part that
turns the appliance on automatically as there is a risk of fire if the appliance is not covered
or placed properly.
– The appliance is intended for use in households only and for similar use!
It is not designed for use in hair salons or for similar commercial use!
– Do not plug the power cord in the electrical socket and do not unplug it with wet hands
or by pulling the power cord!
– Do not leave the appliance in operation unattended!
– Switch off the appliance right after its use, unplug it from power supply and let it cool down.
Then put it on a safe dry place, out of reach of children.
– NOTICE – Some parts of this product may become very hot and cause burns.
Take special care when children or handicapped persons are present.
– Holes for air ventilation must not be covered. Also, do not put the appliance in the "on"
position on soft surfaces (e. g. bed, towels, sheets, carpet), the duct could get covered.
– When the appliance is overheated, the automatic heat fuse is activated and it disconnects
power supply. If it happens, switch off the appliance and unplug it from the socket.
Remove possible visible obstacles preventing air flow and let the appliance cool down.
– Never put the power cord on hot surfaces and never let it hang over table edge or worktop
edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn and fall
down, causing a serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
– Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire, burn, hair damage) in the case of
non-compliance with the safety instructions above.
II. FEATURES OF THE DEVICE (FIG. 1)
A – propulsion unit
A1 – temperature and air flow intensity switch
position 0 – off
position ( ) 1 – minimal temperature and maximal air flow intensity
position ( ) 2 – medium temperature and minimal air flow intensity
position ( ) 3 – maximal temperature and air flow intensity
A2 – left/right rotation button
A3 – attachment arrest button
A4 – turning joint of the power supply
A5 – supply cord
A7 – loop for hanging
B – round brush
C – round brush
D – travel case
38 mm (rotary)
50 mm (rotary)
14 / 31