Operating Precautions - Ulsonix Ulx-Beta-R800 Bedienungsanleitung

5. After cleaning, press the cleaning key to the middle position, wait for the side and main brushes to lift, turn
the key switch counterclockwise, and remove the key.

Operating Precautions

• Do not use the product to pick up items that can easily get tangled, such as cords and cables.
• Every 30 minutes, toggle the dust-shaking lever to vibrate dust for 1 minute.
• Avoid sweeping burning cigarette butts or other hot objects.
• Only trained personnel should operate the equipment.
• Operators should not use the equipment under the influence of alcohol or other mental impairments.
• Operators must read and adhere to the procedures in this manual.
• Ensure no foreign objects, such as rags or tools, are on the equipment before starting. If abnormal noise is
detected, stop the machine immediately for inspection and take protective measures.
• If abnormal noise occurs during operation, stop immediately for inspection and apply necessary
protective measures.
Maintenance
• Before cleaning, repairing, or replacing parts, ensure the equipment is turned off, remove the switch
key, and disconnect the battery connection line.
• All maintenance, overhaul, or repair work must be performed by specialized personnel or at an
authorized service center.
• Machine maintenance must be performed by professionals, with regular maintenance intervals.
During maintenance, the equipment must be stopped, the power switch turned off, and the battery
connection line disconnected.
• To maintain the machine in good condition, it is recommended to conduct a thorough overhaul every
six months. For safety, a professional and technical personnel must perform a complete overhaul
every three years.
• Personnel responsible for operating the machine must receive timely training and maintain accurate
maintenance records.
Regular Maintenance Checks
1 Inspect the belt
2 Check for tangles in the main brush (e.g., ropes)
3 Clean the filter dust
4 Replace the filter
5 Inspect the width of main and side brushes
6 Check battery fluid levels
7 Inspect motor brushes
EN
Maintenance Task
Interval (Hours)
8 40 150 500
√
√
√
√
√
√
1500
√