AIRFORCE INNOVA SLIM PRO 90 Montage- Und Gebrauchsanweisung Seite 19

A
This device allows you to choose the operating mode (suction or filtering) depending on the
installation.
When you first turn it on, for about ten seconds the display shows which mode is active.
Filtering: the display shows the letter F
Suction: the display shows the letter A
During this phase, you can change the mode by acting on the slider:
To confirm the desired mode, press the button
To recall the choice of the operating mode, remove and re-apply voltage to the device.
Note: if the voltage is lost again, the device displays the last setting selected; to confirm, press the
button or wait 15 seconds; to change this mode, use the slider to select the preferred mode;
to confirm, press the button
Turning the suction on and off:
1. Touch the slider
2. Set the extractor speed level within 3 seconds by touching the slider control (from 1 to 9). The
extractor turns on at the set extraction speed.
Set a higher or lower level using the slider control.
3. Set the extractor speed level to "0" to turn off the extractor.
4. Turn off the induction hob by touching the on/off button.
Note: in filter mode, when the device is turned off, the extraction remains on for 20 minutes at
minimum speed, to allow any condensation that may have formed during the cooking phases to
evaporate.
Intensive:
You can use the Boost function to extract at the highest level for a period of up to 6 minutes. (In
recirculation mode there is no time limit and the Boost function remains active.)
1. Move the slider until "P" appears on the display.
Once the maximum allowed time has elapsed, the extractor speed will be reduced to level 9.
Note: In recirculation mode there is no time limit and the Boost function remains active.
2. Set the extractor speed level to "0" to turn off the extractor.
To recall the choice of operating mode, remove and reconnect the power to the device.
3. Turn off the induction hob by touching the on/off button.
FUNZIONAMENTO OPERATION
Display
19 19
EN I