Beemoo PRO MULTI 2 Bedienungsanleitung Seite 9

5-1. Apply the brake before folding the stroller.
5-2. Press the handle adjustment button and slide the handle to its
lowest position.
5-3. Remove the seat and/or carrycot by pressing the buttons on both
sides of the seat, pull the seat up to remove it.
Note: You do not need to remove the seat when folding the stroller
when only one seat section is attached.
5-4. Stand at the front of the stroller. Press the buttons on the sides of
the chassis in the direction of the marked arrows and lift it to fold
the chassis.
5-5. Push the chassis down in the direction of the arrow.
5-6. Push down as far as possible and secure the hook on the side to
prevent the stroller from unfolding during transport.
Install/Remove the front, back seat adapter
6-1. Install the front seat adapters: Insert the adapters on both sides into
hinge points until you hear each side click into place.
6-2. Remove the front seat adapters: Separate the adapter clip point by
using your finger. Pull the adapter to remove it.
6-3. Install the back seat adapters: Insert the adapters on both sides into
hinge points until you hear each side click into place.
6-4. Remove the back seat adapter: Press the release button and pull
the adapter upwards to remove it.
IMPORTANT! In single seat mode, seat adapters are not needed.
Please install the seat directly on to chassis.
USING YOUR STROLLER
7-1. Lock the front wheel by pushing the swivel wheel lock downwards.
Unlock the swivel function by pushing the lock upwards.
7-2. To lock the rear wheel, push the brake pedal down, push the stroller
until the rear wheels locks.
7-3. To unlock the rear wheel, push the brake pedal up.
7-4. Press and hold the adjustment button on the handle and slide the
handlebar to desired height. The handlebar will click into place.
UK
9