Beemoo PRO MULTI 2 Bedienungsanleitung Seite 8

UK
ASSEMBLING AND FUNCTIONS
Note! All pictures shown are for illustration purpose only.
Actual product may vary due to product enhancement.
Install/Remove the Seat
1-1. Slide both seat moldings down until they click into position.
1-2. Pull the seat to make sure it is fully engaged.
IMPORTANT! In single seat mode, seat adapters are not needed.
Please install the seat directly on to chassis.
Install/Remove the Wheels
2-1. Insert the front wheel into the tube of the frame until it clicks into
position.
2-2. To remove the front wheels: Press the button and pull the front
wheel out.
2-3. Insert the rear wheel into the tube of the frame until it clicks into
position.
2-4. To remove the rear wheels: Press the release button and pull the
rear wheels out.
Canopy attachment
3-1. Attach the canopy to the seat frame by pressing down the black clip
of the canopy. Make sure the clip's attachment hole fits over the
nob on the side of the seat frame.
3-2. Zip up the canopy and attach the Velcro on the back of the seat.
Install/Remove the Bumper bar
4-1. To attach the bumper bar, insert its attachment points into openings
on seat section until you hear each side click into place.
4-2. To remove the bumper bar, press the release buttons on both sides
of the seat and pull the bumper bar out.
Folding the Stroller
Warning: Always remove your child from the stroller prior to
folding of stroller.
8