Werbung
Vorbereitung
Lösen Sie die Schraube der Glockenhalterung und befestigen
Sie die Glocke an der Lenkstange.
Positionieren Sie die Glocke so, dass ihr Klang laut und deutlich
zu hören ist. Ziehen Sie dann die Schraube der Glockenhalte-
rung fest.
Öffnen Sie den Schnellspannhebel, stellen Sie die gewünschte
Lenkerhöhe ein und befestigen Sie den Schnellspannhebel
wieder.
4.Remove the screw from the bell and a�ach the
bell to the handlebar.
5.Adjust the posi�on of the bell to make sure
6. To adjust the height of the handlebar, open
the sound of the bell is crisp， then lock the
the quick-release lever and slide theT-bar to the
screw.
desired posi�on and resecure the quick-release
4.Remove the screw from the bell and a�ach the
lever to lock into place.
bell to the handlebar.
Note: The T-bar has a 5.9 inch adjustment
range. Please do not adjust the height outside
the range, otherwise there is a risk of wire
10
9
8
breakage.
7
6
5
4
3
2
1
7.The tension of the quick-release lever
can be adjusted by manually �ghtening or
loosening the Allen bolt. Be careful not to
overtighten.
You should always be able to open and
6. To adjust the height of the handlebar, open
close the quick-release lever by hand and
the T-bar should slide freely when the
the quick-release lever and slide theT-bar to the
quick-release is open.
desired posi�on and resecure the quick-release
lever to lock into place.
Note: The T-bar has a 5.9 inch adjustment
range. Please do not adjust the height outside
the range, otherwise there is a risk of wire
breakage.
5.Adjust the posi�on of the bell to make sure
the sound of the bell is crisp， then lock the
screw.
10
9
8
7
6
5
4
3
2
1
7.The tension of the quick-release lever
can be adjusted by manually �ghtening o
loosening the Allen bolt. Be careful not to
overtighten.
5.Adjust the posi�on of the bell to make
You should always be able to open and
the sound of the bell is crisp， then lock
close the quick-release lever by hand and
screw.
the T-bar should slide freely when the
quick-release is open.
10
9
8
7
6
5
4
3
2
1
7.The tension of the quick-release le
can be adjusted by manually �ghten
loosening the Allen bolt. Be careful
overtighten.
You should always be able to open a
06
close the quick-release lever by han
the T-bar should slide freely when t
quick-release is open.
11
Werbung
