Overmax Multipic VEER Bedienungsanleitung Seite 15

REMOTE CONTROL (FIG. B)
1.
ON/OFF switch
2.
Switch for NightSky star projector
mode
3.
Change to previous NightSky mode
image
4.
Change to next NightSky mode
image
5.
Activate Ambiente mode
6.
Move up
7.
Move down
Important! To prevent damage, turn o the device before unplugging the
power cord from the outlet.
Supported formats:
•
Video formats: DAT/MPG/MPEG/AVI/MP4/MKV/MOV/AVI
•
Audio formats: MP3/MP4
•
Image formats: JPG/BMP/PNG
PROJECTOR OPERATION
CONNECTION TO POWER SUPPLY
To charge the device, connect the power adapter with cord (12, Fig. A) to the
projector's charging port (5, Fig. A) and to a power source. Correct charging
connection is indicated by the red light on the switch (1, Fig. A).
ON AND OFF SWITCHING
When the projector is connected to a power source, it enters standby mode,
and the switch on the top of the housing (1, Fig. A) lights up red. To switch
the projector on or o , press the on/o switch or the on/o button on the
remote control (1, Fig. B). Then confirm the operation.
When the projector is powered on and ready for use, the switch on the top
of the housing (1, Fig. A) will illuminate in white.
SETTINGS
Refer to the table below to adjust the image size and projector distance
(Fig. 1).
Aspect ratio
Image diagonal (metres / inches)
2.22 / 87.4
2.77 / 109
8.
Move left
9.
Move right
10.
OK button
11.
Menu
12.
Homepage
13.
Back
14.
Mute
15.
Volume down
16.
Volume up
16:9
Projection distance (metres / inches)
2.64 / 104.4
3.3 / 130.8
EN