Axis Communications M5526-E Installationsanleitung Seite 3

• Electromagnetic Compatibility (EMC)
Directive 2014/30/EU. See Electromagnetic
compatibility (EMC), on page 3.
• Low Voltage Directive (LVD) 2014/35/EU. See
Safety, on page 4.
• Restriction of Hazardous Substances (RoHS)
Directive 2011/65/EU and 2015/863,
including any amendments, updates or
replacements. See Disposal and recycling, on
page 4.
A copy of the original declaration of conformity
may be obtained from Axis Communications AB.
See Contact information, on page 5.
Electromagnetic compatibility (EMC)
This equipment has been designed and tested to
fulfill applicable standards for:
• Radio frequency emission when installed
according to the instructions and used in its
intended environment.
• Immunity to electrical and electromagnetic
phenomena when installed according to the
instructions and used in its intended
environment.
USA
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested using a shielded
network cable (STP) and found to comply with
the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference
equipment is operated
environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
when the
in a commercial
3
instruction manual,
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense. The product shall be
connected using a shielded network cable (STP)
that is properly grounded.
Contact information
Axis Communications Inc.
300 Apollo Drive
Chelmsford, MA 01824
United States of America
Tel: +1 978 614 2000
Canada
This digital apparatus complies with CAN ICES-3
(Class A). The product shall be connected using a
shielded network cable (STP) that is properly
grounded. Cet appareil numérique est conforme à
la norme CAN NMB-3 (classe A). Le produit doit
être connecté à l'aide d'un câble réseau blindé
(STP) qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements
for RF emission according to the Class A limit of
EN 55032. The product shall be connected using
a shielded network cable (STP) that is properly
grounded. Notice! This is a Class A product. In a
domestic environment this product may cause RF
interference, in which case the user may be
required to take adequate measures.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class A limit of
AS/NZS CISPR 32. The product shall be connected
using a shielded network cable (STP) that is
properly grounded. Notice! This is a Class
A product. In a domestic environment this
product may cause RF interference, in which case
the user may be required to take adequate
measures.
Japan
この装置は、クラスA機器です。この装置
を住宅環境で使用すると電波妨害を引き起
may cause harmful