Nitho NEXUS Schnellstartanleitung Seite 8

RGB LIGHT EFFECT SETUP
You can long press the "LIGHT" button at the back of the
controller to switch or turn off the RGB light effect.
Press the "LIGHT" + "R3" button to switch four light effect
modes:
Dazzling Light Mode
Press "LIGHT" + "L3" button briefly to pause and save the
current effect mode.
Single Color Light Mode
Press "LIGHT" + "L3" briefly to switch the light color.
Single Color Breathing Light Mode
Press "LIGHT" + "L3" briefly to switch the light color.
Single-Color Breathing Cycle Light Mode
Press "LIGHT" + "L3" briefly to pause and save the current
mode, press again to resume the Breathing mode.
In any mode, press "LIGHT + D-pad UP/DOWN" button to
adjust RGB light brightness:
"LIGHT+D-pad UP" increase brightness.
"LIGHT+D-pad DOWN" decrease brightness.