Nitho NEXUS Schnellstartanleitung Seite 4

NOTE BEFORE USING NEXUS
Before connecting NEXUS controller for the first time, fully
charge the battery.
To recharge the battery, plug the supplied USB cable into the
controller and a USB port.
In controller charging mode, the LED1-LED4 indicators blinks
slowly while charging, and turns off when charging is
complete.
Note: When the controller's battery is low, the central LEDs
will blink rapidly and it will enter in sleep mode
WIRED CONNECTION SETUP
SWITCH
®
1.While the controller is off, directly connect the USB data
cable to the Switch console's USB port.
2.The Controller will automatically connect back to the
console through Bluetooth wireless mode after unplug the
USB cable.
Note: need to open the wired controller connection option
in the Console Setting
PC
Connect the USB data cable to NEXUS controller and the PC.
Enter X-Input mode (default), then the LED1+LED4 light will
turn on
Press and hold the "-" and "+" button for 3 seconds to enter
the D-Input mode, LED2+LED3 light will turn on.
RESET FUNCTION