Beemoo ONE Bedienungsanleitung Seite 13

- Insert the seat onto the brackets until it clicks into place. Ensure that
both sides of the seat are securely fastened into the frame before
use.
NOTE: The seat may be installed either forward-facing or
rear-facing.
Remove the seat unit:
- Press the release buttons on both sides of seat then lift the seat unit
to remove.
WARNING: Always remove your child from the seat before removing the
seat from the frame.
USER INSTRUCTIONS
6. Using safety harness:
- Assemble the shoulder strap buckle onto waist strap buckle on both
sides.
- Insert the connected harness and waist strap buckles into the sides
of the crotch buckle.
- Press button on the crotch buckle to release.
Adjusting safety harness:
- Hold the plastic slider and pull strap to tighten or loosen.
- To adjust the height of shoulder straps, turn the plastic stopper on
the back of seat and pass it through the openings in the PE board
and seat fabric. Reinsert stopper at seat opening closest to child's
shoulders. Pass back through seat fabric and PE board. Tug on
strap to ensure stopper is locked. Repeat on both sides.
WARNING:
• Always use the restraint system with the crotch strap in combination with
the shoulder straps and waist belt.
• Avoid serious injury from falling or sliding out. Always properly adjust and
fasten safety harness.
UK
2
13