VEVOR RC-1836 Bedienungsanleitung Seite 7

STEP 3:
For this step you'll need the above assembly you just created, and 2 Bike
Arm Assemblies (part E) At this time, you'll want to slide a Bike Arm
Assembly (Part E) onto each Upright tube. Lightly tighten each arm just to
hold it in place for now.
STEP 4:
For this step you'll need the Top Bar (Part D), 2 uprights (Part C), 2 Philips
head screws For this step we'll attach the other set of Uprights (Part D) to
the Top Bar. As before, slide the Upright tube over the Top Bar Tube and
line up the holes. Insert a Philips head screw and tighten. Repeat for the
other upright so your assembly resembles Figure 4b below.
- 6 -