Remote Control - Jab Qmotion Meridian-E Rollo Montage- Und Programmieranleitung

REMOTE CONTROL

How can I program a new remote control? I How can I add a remote control?
POSSIBILITY 1
Use a programmed remote control
Blind has to be in the upper end position!
1. Press the programming button on the programmed remote control.
2. Press the 50% button on single-channel remote control or "ALL" on multi remote control
and hold until the blind moves.
3. Pull the blind at least 15 cm downwards, motor reacts (up-down movement).
4. Select channel (in case of a multi remote control).
5. Press the programming button on the remote control to be programmed.
6. Press the up button and hold until up-down movement, then the blind moves up,
and again up-down movement.
POSSIBILITY 2
Without a programmed remote control
1. Remove batteries and reinsert after 30 seconds
2. Select channel in case of a multi remote control
3. Press the programming button on the reverse (single-channel remote control twinkles,
multi remote control shows running light)
4. Press the up button and hold until motor starts
5. Blind can be stopped with the down button
Subject to technical changes
o
Ï
EN | 21