Intermediate Positions - Jab Qmotion Meridian-E Rollo Montage- Und Programmieranleitung

meridian-E | PROGRAMMING INSTRUCTIONS
ADVICE
The following program steps are only required to change standard settings!
LOWER END POSITION
How can I adjust a new lower end position?
You have several meridian-E blinds on one channel of the remote control, but only want to adjust one?
Only meridian-E blinds where step 3 is executed will switch into the learn mode to learn the new positions.
The other meridian-E blinds will move according to the pushed button, but they won't be adjusted.
1. Press the down button and the meridian-E blind moves into the previous end position.
2. Hold the down button until the meridian-E blind reacts (up-down movement).
3. Pull the meridian-E blind at least 15 cm downwards, motor reacts (up-down movement).
4. Adjust requested end position.
5. Press the down button and hold until the meridian-E blind reacts (up-down movement).
6. Press the down button again to move to the adjusted end position.

INTERMEDIATE POSITIONS

How can I adjust a new intermediate position?
Intermediate stages at 25%, 50% and 75% are configured as standard. You can change the intermediate
stages for all or separate meridian-E blinds into individual positions. Only meridian-E blinds where step 3 is
executed will switch into the learn mode to learn the new positions. The other meridian-E blinds will move
according to the pushed button, but they won't be adjusted.
1. Press the 25%, 50% or 75% button and the meridian-E blind moves into the previous position.
2. Hold the 25%, 50% or 75% button until the meridian-E blind reacts (up-down movement).
3. Pull the meridian-E blind at least 15 cm downwards, motor reacts (up-down movement).
4. Adjust requested position.
5. Press the 25%, 50% or 75% button and hold until the blind reacts (up-down movement).
6. Press the 25%, 50% or 75% button to move to the adjusted intermediate position.
Subject to technical changes
É
r
q
EN | 19