JAB QMotion meridian-E Rollo Montage- Und Programmieranleitung Seite 18

meridian-E | ASSEMBLY INSTRUCTIONS
Please note: The meridian-E blind was especially adapted on the commanded mounting version and thus it is
not allowed to change anything. It is only possible to switch from a ceiling fixation with clip to a wall fixation
with brackets. Furthermore you can only switch from wall fixation with clip to a ceiling fixation with brackets.
$
Fix the two outer brackets on the ceiling or wall, with a distance of 55-70 mm to the end of the carrier section
profile. Place further brackets in regular distances. For ceiling fixation without brackets please respect the
necessary distance to the wall.
Tilt the meridian-E blind forwards, put the carrier section profile into the lower part of the brackets and click it
backwards into the brackets. Alternatively you could insert the profile on the top first and then click it into the
bottom (only if there's enough space above).
DISMANTLING OF meridian-E BLIND
Use a flat screwdriver for the dismantling. Put it between the carrier section profile and clip and loosen the
connection by turning the screwdriver.
EN | 18
55 – 70
35
2
2
1
1
35