Werbung
of the stove). If this is not
possible, there should be a
mechanism (fuse, switch,
switch, etc.) on the electrical
installation
to which
product is connected, in
compliance
with the electrical
regulations and separating all
poles from the network.
• The product must not be
plugged into the outlet during
installation, repair, and
transportation.
• Do not plug the product into
an outlet that is loose, has
come out of its socket,
broken, dirty, oily, with risk of
water contact (for example,
water that may leak from the
counter).
• Never touch the plug with
wet hands! To unplug, do not
hold the cord, always hold
the plug.
• Make sure that the product
plug is securely plugged into
the outlet to avoid arcing.
• Plug the product into an
outlet that meets the voltage
and frequency values
specified on the type label.
• Do not jam the power cord
under
and
behind
product.
Do not put a heavy
object on the power cord.
6/EN
the
is
the
The power cord should not
be bent, crushed,
into contact with any heat
source.
• While the oven is operating,
its back surface also gets hot.
Power
cords
the back surface,
connections
damaged.
• Do not jam the electric cables
into the oven door and pass
them
over
hot
may cause the oven to short
circuit
and
catch
result of the cable melting.
• Use original cable only. Do
not use cut or damaged
cables
or extension
• If the power cord is damaged,
it must be replaced by a
manufacturer,
service or a person to be
specified by the importer
company
in order to prevent
possible dangers.
• WARNING: Before replacing
the oven lamp, be sure to
disconnect
the product from
the mains supply to avoid the
risk of electric shock. Unplug
the product or turn off the
fuse
from
the fuse
and come
must
not touch
may be
surfaces.
You
fire as a
leads.
an authorized
box.
Werbung
