Profile PLUG-IN Bedienungsanleitung Seite 30

USE THIS HEATER ON A HORIZONTAL AND STABLE SURFACE.
IF THE POWER CORD IS DAMAGED, IT MUST BE REPLACED BY THE
MANUFACTURER OR ITS SERVICE AGENT OR SIMILARLY QUALIFIED
PERSON TO AVOID DANGER. OR SIMILARLY QUALIFIED PERSON TO
AVOID DANGER.
IT IS STRICTLY FORBIDDEN TO USE THE SAME SOCKET WITH OTHER
LARGE ELECTRICAL APPLIANCES.
REMOVE THE PLUG FROM THE SOCKET WHEN NO ONE IS AROUND.
DO NOT USE THE HEATER IN PLACES WHERE YOU CAN EASILY GET A
SHOCK OR FALL OVER.
IF THERE IS SOMETHING WRONG WITH THE HEATING ELEMENT,
SWITCH OFF THE APPLIANCE AND IMMEDIATELY UNPLUG IT FROM
THE SOCKET AND SEND IT TO THE SERVICE DEPARTMENT.
WARNING: DO NOT COVER THE HEATING ELEMENT TO PREVENT
OVERHEATING.
THE HEATING ELEMENT SHOULD NOT BE LOCATED DIRECTLY UNDER
A WALL SOCKET.
THE HEATING WIRE USED IS SPECIALLY TREATED AND HAS A LONG
SERVICE LIFE. DO NOT USE ANY OTHER HEATING WIRE.
KEEP FLAMMABLE MATERIAL SUCH AS FURNITURE, CUSHIONS,
BEDDING, PAPER, CLOTHING, CURTAINS, ETC. AT LEAST 100 CM AWAY
FROM THE HEATER.
KEEP THE AIR INLET AND OUTLET FREE OF OBJECTS: AT LEAST 1 M IN
FRONT AND 50 CM BEHIND THE HEATER.
ONLY CONNECT THE HEATER TO A SINGLE-PHASE SOCKET WITH A
MAIN VOLTAGE AS INDICATED ON THE TYPE PLATE.
DO NOT LEAVE YOUR HOME WHILE THE APPLIANCE IS IN
OPERATION: MAKE SURE THE SWITCH IS IN THE OFF(0) POSITION
AND THE THERMOSTAT IS IN THE MINIMUM POSITION. ALWAYS
UNPLUG THE APPLIANCE.
WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS WHEN
OCCUPIED BY PERSONS
WHO ARE UNABLE TO LEAVE THE ROOM INDEPENDENTLY UNLESS