Bosch GCL 2-50 C Professional Originalbetriebsanleitung Seite 19

Temporarily Deactivating Automatic Shut-Off
To deactivate the automatic shut-off function, hold down the
laser mode button (8) for at least 3 s (with the measuring
tool switched on). If the automatic shut-off function is deac-
tivated, the laser beams will flash briefly as confirmation.
Note: If the operating temperature exceeds 45 °C, automatic
shut-off can no longer be deactivated.
To activate the automatic shut-off function, switch the meas-
uring tool off and on again.
Setting the Operating Mode
The measuring tool has several operating modes, which you
can switch between at any time:
– Cross-line and point mode: The measuring tool gener-
ates a horizontal and a vertical laser line as well as two
vertical laser points, one facing up, the other down. The
laser lines cross at a 90° angle.
Working with Automatic Levelling
Sequence of actions
On/off switch (2) in position "
Press the laser operating mode
Laser
button (8) once
Press the laser operating mode
Laser
button (8) twice
Press the laser operating mode
Laser
button (8) three times
Press the laser operating mode
Laser
button (8) four times
If, during work with automatic levelling, you switch to "work-
ing with pendulum lock" mode (on/off switch (2) in position
Working with the pendulum lock
Sequence of actions
On/off switch (2) in position " On"
Press the laser operating mode
Laser
button (8) once
Press the laser operating mode
Laser
button (8) twice
Press the laser operating mode
Laser
button (8) three times
If, during work with pendulum lock, you switch to "working
with automatic levelling" mode (on/off switch (2) in position
On), the first combination option of this mode's indicat-
ors is always activated.
Bosch Power Tools
– Horizontal line mode: The measuring tool generates a
– Vertical line mode: The measuring tool generates a ver-
– Point mode: The measuring tool generates two vertical
All operating modes, apart from point operation, can be se-
lected with both automatic levelling or the pendulum lock.
To change the operating mode, press the laser mode
button (8).
Horizontal line Vertical line
mode
●
On"
Cross-line mode
●
–
–
●
Cross-line mode
is always activated.
Horizontal line Vertical line
mode
●
Cross-line mode
●
–
●
Cross-line mode
Receiver Mode
Receiver mode must be activated when working with the
laser receiver (29), regardless of which operating mode is
selected.
horizontal laser line in front of it.
tical laser line in front of it.
Positioning the measuring tool in the room displays the
vertical laser line on the ceiling beyond the top laser
point.
If the measuring tool is positioned directly against a wall,
the vertical laser line almost encircles the entire space
(360° line).
laser points, one facing up, the other down.
Point mode Pendulum lock
mode indicator (5)
● ●
– –
● –
– ●
● ●
On), the first combination option of this mode's indicators
Point mode Pendulum lock
mode indicator (5)
● –
– –
● –
● –
English | 25
Figure
B
C
D
E
B
Figure
F
Red
Red
Red
F
Red
1 609 92A 7LS | (11.05.2022)