Ezviz RC3P Bedienungsanleitung Seite 4

cause explosion.
• After the RGB camera is contaminated with dust during use, it is
recommended to use the air blower to clean the camera, or use a paper
towel and soft dry cloth to wipe and clean, don't use rough or hard
materials, so as to avoid scratches on the glass surface of the vision
module.
• If the rear surface of the robot is too dusty, it will affect the recharging of
the robot. It is recommended to clean it regularly or as needed. It is also
recommended to use a paper towel or soft dry cloth to clean it.
• If the surface of the edge sensor on the side of the robot is contaminated
with lots of dust, it will affect the posture and mapping positioning effect
of the robot when walking along the wall. It is recommended to clean it
regularly or as needed. Since the sensor is located inside the body, it is
recommended to use the air blowing tool/paper towel/soft dry cloth for
cleaning the camera to wipe the sensor. Don't put your fingers into it for
cleaning.
• The bottom of the robot is easy to be contaminated with lots of dust, so
it is recommended to clean it regularly or as needed.
• Please use the device according to the instructions in the manual. Any
loss and injury caused by improper use shall be borne by the user.
• Please don't touch the plug or any electrified part of the product with
your wet hands in case of electric shock hazard.
• If you will not use the product for a long time, please turn off the power
and unplug the charging plug.
3